Publicidad
Idiomas disponibles
Idiomas disponibles
Step 4:
Once you have pushed the 6 frame
pieces (#A3) together and screwed
them tight, lift the metal frame and
insert the feet you assembled in step
1 & 2 into the brackets provided for
this on the underside (Fig.5). The
structure should now be alone &
stand stable (Fig.6).
Note: Pay attention to the slight
curvature of the feet. If a stand does
not fit into the openings, turn
180 °.
Step 5:
Now connect the upper protective net holder (#B1)
to the lower protective net holder (#B2), as shown
in Fig. 7. To do this, insert the wide end of the upper
protective net holder with a hole on the side over the
narrow end of the lower one. To do this, press the
click fastener on the lower protective net holder and
slide the upper protective net holder over it so that
this engages automatically. Both parts should now be
firmly connected to each other.
Repeat this step a total of six times.
Step 6:
Now put a cap (#B3) into the upper
end of the tube (Fig.8) and pull it
over two foam covers (#B4) over
the combined protective net holder
(Fig.9).
Repeat this step a total of six times.
Figure 5
Figure 6
it
Figure 7
Figure 8
27
Figure 9
EN
Publicidad
