Items Supplied; Proper Use; Technical Data; Before Starting The Equipment - EINHELL TE-LL 360 Manual De Instrucciones

11 ¼ inch male thread with wheel tripod
12 Feet tripod
13 Head fi xation tripod

2.2 Items supplied

•
Open the packaging and take out the equip-
ment with care.
•
Remove the packaging material and any
packaging and/or transportation braces (if
available).
•
Check to see if all items are supplied.
•
Inspect the equipment and accessories for
transport damage.
•
If possible, please keep the packaging until
the end of the guarantee period.
Danger!
The equipment and packaging material are
not toys. Do not let children play with plastic
bags, foils or small parts. There is a danger of
swallowing or suff ocating!
•
Cross-line Laser
•
Mounting device Laser
•
Bag Laser
•
Tripod
•
Bag Tripod
•
Original operating instructions

3. Proper use

The cross-line laser uses lasers to project lines
onto the wall and is therefore designed for ali-
gning objects such as tiles, windows, doors or
pictures.
The equipment is to be used only for its prescri-
bed purpose. Any other use is deemed to be a
case of misuse. The user / operator and not the
manufacturer will be liable for any damage or inju-
ries of any kind caused as a result of this.
Please note that our equipment has not been de-
signed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
Anl_SA_TE_LL_360_SPK8.indb 13 Anl_SA_TE_LL_360_SPK8.indb 13
GB

4. Technical data

See warranty card of your country.

5. Before starting the equipment

5.1 Inserting batteries (Fig. 2)
•
Turn off the equipment using the ON/OFF
switch (1)
•
Open the battery compartment cover (6) by
pushing the nib (a) towards the ¼ inch female
thread (7).
•
Insert the batteries (b), ensuring that you fit
them the right way round.
•
Close the battery compartment cover (6)
again, making sure that it locks securely
If the LED indicator fl ashes red continuously even
though the device is upright, this means that the
batteries are fl at. Replace them as described
above.
5.2 Using the height-adjustable mounting
(Fig. 3/Item 8)
You can fasten the supplied mounting to a wall
using the wall bracket (c), to metal surfaces using
the magnets at the back (d), or to a tripod using
the ¼-inch or ⅝ inch thread at the bottom (e).
To fi t the equipment to the mounting, proceed as
follows:
•
Place the equipment by the female thread (7)
on the male thread (10) of the mounting (8)
•
Screw the laser to the mounting with the help
of the wheel
•
Use the height adjuster (9) to adjust the laser
to the required height.
To dismantle, proceed in reverse order.
5.3. Montaje Laser en el Trípode
•
Colocar el láser con la rosca interior (7) en
la rosca exterior (11) del cabezal (13) del
trípode.
•
Fijar el láser con la ayuda de la rueda girato-
ria roja (b) debajo del cabezal(13) del trípode,
atornillando el laser
El desmontaje se realiza de manera inversa como
descrita en el punto 5.3
- 13 -
18.07.2017 14:38:14 18.07.2017 14:38:14