Bosch GCU18V-30 Instrucciones De Funcionamiento Y Seguridad página 4

contact accidentally occurs, flush with water.
If liquid contacts eyes, additionally seek medi-
cal help. Liquid ejected from the battery may
cause irritation or burns.
e. Do not use a battery pack or tool that is
damaged or modified. Damaged or modified
batteries may exhibit unpredictable behaviour
resulting in fire, explosion or risk of injury.
f. Do not expose a battery pack or tool to fire
or excessive temperature. Exposure to fire or
temperature above 265 °F may cause explo-
sion.
g. Follow all charging instructions and do not
charge the battery pack or tool outside the
Use clamps or another practical way to secure
and support the workpiece to a stable plat-
form. Holding the work by your hand or against
the body leaves it unstable and may lead to loss
of control.
Always make sure the work surface is free
from nails and other foreign objects. Cutting
into a nail can cause the bit and the tool to jump
and damage the bit.
Never hold the workpiece in one hand and the
tool in the other hand when in use. Never place
hands near or below cutting surface. Clamp-
ing the material and guiding the tool with both
hands is safer.
Never lay workpiece on top of hard surfaces,
like concrete, stone, etc... Protruding cutting
bit may cause tool to jump.
Always wear safety goggles and dust mask.
Use only in well ventilated area. Using personal
safety devices and working in safe environment
reduces risk of injury.
After changing the bits or making any ad-
justments, make sure the collet nut and any
other adjustment devices are securely tight-
ened. Loose adjustment device can unexpect-
edly shift, causing loss of control, loose rotating
components will be violently thrown.
Never start the tool when the bit is engaged
in the material. The bit cutting edge may grab
the material causing loss of control of the cutter.
2610067307_GCU18V30_202203.indd 4
General Power Tool Safety Warnings
Cut Out Tool Safety Rules
temperature range specified in the instruc-
tions. Charging improperly or at temperatures
outside the specified range may damage the
battery and increase the risk of fire.
6. Service
a. Have your power tool serviced by a qualified
repair person using only identical replace-
ment parts. This will ensure that the safety of
the power tool is maintained.
b. Never service damaged battery packs. Ser-
vice of battery packs should only be per-
formed by the manufacturer or authorized
service providers.
Always hold the tool with two hands during
start-up. The reaction torque of the motor can
cause the tool to twist.
When routing or cutting, the direction of feed
with the bit's cutting edge into the material is
very important. Always feed the bit into the
material in the same direction as the cutting
edge is exiting from the material. When view-
ing the tool from the top, the bit rotates clock-
wise. If the tool is between the workpiece and
your body, then feed the tool to your right. If the
workpiece is between the tool and your body,
then feed the tool to your left. Feeding the tool
in the wrong direction causes the cutting edge
of the bit to climb out of the work and pull the
tool in the direction of this feed.
Never use dull or damaged bits. Sharp bits
must be handled with care. Damaged bits can
snap during use. Dull bits require more force to
push the tool, possibly causing the bit to break.
Never touch the bit during or immediately af-
ter the use. After use the bit is too hot to be
touched by bare hands.
Never lay the tool down until the motor has
come to a complete standstill. The spinning bit
can grab the surface and pull the tool out of your
control.
Never use bits that have a cutting diameter
greater than the opening in the base.
-4-
3/30/22 8:33 AM