Descargar Imprimir esta página

La Sommeliere MT145TZ Manual De Instrucciones página 23

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Before using this appliance
Remove the exterior and interior packing.
Before connecting the appliance to the power source, let it stand upright for approximately 24
hours. This will reduce the possibility of a malfunction in the cooling system from handling during
transportation.
Clean the interior surface with lukewarm water using a soft cloth.
When disposing your appliance, please choose an authorized disposal site.
Place your wine cooler on a floor that is strong enough to support it when it is fully loaded. To
level your Wine cooler, adjust the front leveling leg at the bottom of the wine cooler.
Adequate ventilation is required, do not block the front air outlet.
This wine cellar is designed for free-standing
Connect the cellar to a single socket, leaving a 30-mm gap between the back of the cellar and the
wall. Be careful to support it, so that your wine cellar is perfectly level (use of a spirit level is
recommended). This will prevent any movement due to instability, causing noise and vibration,
and will ensure that the door seals perfectly.
This appliance is intended to be used exclusively for the storage of wine.
This appliance is using flammability refrigerant. So never damage the cooling pipe work during
the transportation.
Caution
Store wine in sealed bottles.
Do not overload the cabinet.
Do not open the door unless necessary.
Do not cover shelves with aluminum foil or any other shelf material which may prevent air
circulation.
Should the wine cooler be left empty for long periods it is suggested that the appliance is
unplugged, and after careful cleaning, leave the door ajar to allow air to circulate inside the
cabinet in order to avoid possible condensation, mold or odors forming.
CAUTION: please keep the appliance away from substance, which can cause ignition.
Install your wine cellar
The MT145TZ wine cellar can be installed in freestanding or in built-in position
See installation diagram:
4. INSTALLATION INSTRUCTIONS
23

Publicidad

loading