Publicidad
Idiomas disponibles
Idiomas disponibles
opened. A light bulb icon is visible on the display screen.
•
Permanent mode: the lighting is on continuously. A light bulb icon is visible on the
display screen.
3. Actual temperature display
4. Button to increase the set temperature by 1°C
5. Combination key to change the temperature unit between degrees Celsius "°C" and
degrees fahrenheit "°F". Hold the button pressed for 3 seconds to switch from one
temperature unit to another.
6. Button to decrease the set temperature by 1°C
Middle and lower zone panel
1. Infrared sensors
2. Button to increase the set temperature by 1°C
3. Button to decrease the set temperature by 1°C
4. Display of the actual temperature of the middle zone (left side of the screen) and lower
(right side of the screen)
5. Button to increase the set temperature by 1°C
6. Button to decrease the set temperature by 1°C
Handle installation
There is a handle in the accessory bag, please follow below instructions to install handle.
1.
Pull out the door gasket in the area where the handles are to be installed. The door gasket
can be easily pulled out by hand, no tools are required. Please note do not use too much force to
avoid damaging door gasket.
2.
Align the handle with the screws and tighten the screws. The handle must fit well against the
door frame (DO NOT overtighten the screws as this may damage the handle assembly and the door
frame or door glass).
3.
Reinstall the door seal to its original position to complete the handle installation.
26
Publicidad
