ELECTRICAL REQUIREMENTS
6
The Santa Fe Ultra155/205 plug into a common grounded 115 VAC outlet. Locate the dehumidifier in an area where
the cord's length (9') easily reaches a 115 VAC electrical outlet. The Santa Fe Ultra155 requires a minimum 15 Amp
circuit. The Santa Fe Ultra205 requires a dedicated 20 Amp circuit. If used in an area that may become wet, a GFCI
protected circuit is recommended. Consult local electrical codes for further information.
Santa Fe offers a variety of control devices for use with the Santa Fe Dehumidifier. The control is to be located
remotely from the dehumidifier and placed in the space to be conditioned. A low voltage (24 Volt) control MUST be
used with the Santa Fe Dehumidifier and MUST be connected with low voltage (18-22 gauge) thermostat wire.
WARNING!
THE REMOTE CONTROLS OF THE SANTA FE ULTRA155/205 ARE POWERED BY A LOW VOLTAGE CIRCUIT
(24VAC) AND MUST NEVER CONTACT OR BE CONNECTED TO A HIGH VOLTAGE CIRCUIT.
CAUTION!
DO NOT ALLOW THE 24V TERMINAL TO CONTACT THE COM/DMPR TERMINALS ON THE
SANTA FE ULTRA155/205 OR DAMAGE TO THE TRANSFORMER WILL RESULT.
CAUTION!
SOME OF THE SCREWS TERMINALS ON THE SANTA FE ULTRA155/205 MAY NOT BE USED WITH
CERTAIN CONTROLS AND SHOULD BE LEFT UNCONNECTED.
1. Electrical Precautions
•
Do not install the control where it may not accurately sense the relative humidity such as near HVAC
supply registers, near exterior doors, on an outside wall, near a window, or near a water source.
•
The screw terminals on the Santa Fe Ultra155/205 and the control are labeled to prevent confusion.
•
Be sure to consult the electrical schematic in the CONTROLS Section (page 12) of this manual or
inside the access panel of the Santa Fe Ultra155/205 before making control connections.
2.
Wiring Schematic
8
Santa Fe ULTRA155/205 Installation & Operation Instructions
Santa-Fe-Products.com | 800.533.7533