Descargar Imprimir esta página

Cuisinart Coffee Center BaristaBar SS-4N1 Serie Manual De Instrucciones página 14

Publicidad

ADD WATER
The Add Water light will illuminate when water
is below 10.5 ounces. Simply fill the reservoir
with water and continue to brew as usual.
BREWING WITH THE
HOMEBARISTA
FILTER CUP
The Single-Serve Coffeemaker can be used
with a reusable coffee pod, which allows you
to use your own ground coffee.
The HomeBarista™ Reusable Filter Cup is not
included, but is for sale at most retailers with
®
Cuisinart
products.
1. Fill the filter basket within the reusable pod
with ground coffee, making sure not to fill
past the max indicator. Adjust the amount
to your personal preference. Do not tamp
the grounds. Make sure there are no
grounds remaining on the upper rim of the
filter basket. Close lid.
NOTE: Max fill: 2.5 scoops or 15 grams.
2. Remove the pod capsule holder from the
brewing chamber by pulling toward you.
2a. Drop the reusable coffee pod into the
brewing chamber. There is no need to
snap it into place.
2b. Follow brewing instructions on page 13.
NOTE: To cancel brewing, simply press
the START/STOP knob once again and the
brewing process will be stopped.
Caution: There are two sharp needles
in the brewing chamber that puncture
the pod, one above and one below.
To avoid risk of injury, do not put your
fingers in the brewing chamber.
3. After brewing, raise the handle and remove
the reusable coffee pod. Use caution as
the reusable coffee pod will be hot.
4. Replace the pod capsule holder, ensuring
that the arrow on pod capsule rim aligns
with the arrow on the brewing chamber.
Gently push the pod capsule holder to
snap into place.
NOTE: This Coffeemaker is compatible with
most reusable coffee pods.
TM
REUSABLE
MAKING ESPRESSO
IMPORTANT: Complete the initial cleaning
steps before brewing. Follow instructions in
Setting Up Your Single-Serve Coffeemaker,
page 12.
This machine is compatible with Nespresso
OriginalLine style capsules.
1. If ADD WATER indicator is on, remove
reservoir and fill.
2. Move drip tray to adjustable tray position
to avoid any splashing and more accurate
dispensing of espresso.
3. Place an espresso cup on the drip tray and
select your desired espresso capsule.
4. Turn the START/STOP knob clockwise
to enter ESPRESSO setting mode.
The ESPRESSO indicator will illuminate.
14
®

Publicidad

loading