VONROC EH513AC Traducción Del Manual Original página 6

EN
Stopping the electric heater
Let the machine cool down before turning
off by using the ventilation function.
• Press the on/off button (13).
• The fan indicator flashes and the fan will cool
down the heater for a few minutes.
• Turn the main switch (7) off.
• Pull the plug out of the mains.
Storing the electric heater
• Always let the heater cool down completely
before storing the machine.
• Never wrap the cable around the heater.
Warning! Never store the machine in a wet
or dusty environment
4. MAINTENANCE
Before cleaning and maintenance, always
switch off the machine and remove the
mains plug from the mains.
Cleaning
Let the machine cool down completely
before cleaning.
• Clean the heater with a dry towel or vacuum
cleaner.
• In order to protect the enclosure, don't splash
water onto the heater, and never use a solvent
like gasoline, isoamyl acetate, toluene, etc. to
clean the heater.
• When you store the heater, let it cool down first
and, keep it dry.
Trouble shooting
In case the electric heater does not work well, we
give you subjoined some possible causes and their
solutions.
6
Problem Possible cause Treatment
The heater does The plug is
not operate, loose, bad
even when it connection
is plugged in
and the switch,
No power in
thermostat are
socket outlet
switched on.
The input
voltage is too
high or too low
The heating
element
glowing
The air inlet
grill is blocked
The switch was
not put at
heating setting
The thermostat
The appliance
operated
didn't heat up,
only ventilator
worked
The self-retting
cut-out
operated
The appliance
Abnormal noise is not stands
upright
ENVIRONMENT
Faulty and/or discarded electrical or
electronic apparatus have to be collected at
the appropriate recycling locations.
Only for EC countries
Do not dispose of power tools into domestic waste.
According to the European Guideline 2012/19/EU
for Waste Electrical and Electronic Equipment
and its implementation into national right, power
tools that are no longer usable must be collected
separately and disposed of in an environmentally
friendly way.
Pull out the plug, check the
connection of the plug and
socket. Then connect again.
Insert the plug in a proper socket
Use power supply according to
the rating on the label
Keep the heater far way from
articles like curtain, plastic bag,
paper and other things which
can cover the inlet or can be
easily cover on the air inlet
Turn the switch to heat setting
Turn the thermostat and listen if
there is open/close voice. If there
is no click and the thermostat
is not damaged, the heater will
automatic switch on when the
appliance cooled down
Turn the heater off and inspect
the blockage of inlet or outlet.
Disconnect the plug and wait
at least 10 minutes for the
protection system to reset before
attempting to restart the heater.
Put the heater on a level surface
WWW.VONROC.COM