Publicidad
E N G L I S H
T EC HN IC A L I N F ORMAT IO N
Water pressure
Recommended
Maximum
Hot water temp.
Recommended
Maximum
Max. flow rate
spout
handshower
* Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.
I NSTA LL AT I O N CO N SID E R ATI ONS
⁄ For best results, Hansgrohe recommends that this unit
be installed by a licensed, professional plumber.
⁄ Please read over these instructions thoroughly before
beginning installation. Make sure that you have all
tools and supplies needed to complete the installation.
⁄ This trim is for use with rough 10452181 (not includ-
ed). The rough must be installed and the finished floor
surface completed and made watertight.
This unit is not anti-scald. In Massachusetts, or
if required by local plumbing code, install an
approved water temperature limiting device
conforming to ASSE 1070 (not available from
Hansgrohe).
2
15 - 75 PSI (0.1 - 0.5 MPa)
145 PSI (1 MPa)
120°-140° F (48° - 60° C)*
158°F (70° C)*
5.8 GPM (22 L/min)
1.75 GPM (6.6 L/min)
⁄ Protection against backflow is provided by check
valve and an automatically resetting diverter.
⁄ This showerhead is for use with an automatically
compensating valve rated at 1.3 GPM (4.9 L/min)
or less.
⁄ To prevent scald injury, the maximum output tempera-
ture of the shower valve must be no higher than 120°F
(49°C). In Massachusetts, the maximum output tem-
perature can be no higher than 112°F (44°C).
⁄ Keep this booklet and the receipt (or other proof of
date and place of purchase) for this product in a safe
place. The receipt is required should it be necessary
to request warranty parts.
Publicidad
