Publicidad
Idiomas disponibles
Idiomas disponibles
Installation (continued)
□ Attach sill angle bracket (HH) to support bracket at
marked positions with 3/4 inch flat head bolts and
nuts (NN). Hand tighten only at this point.
□ Insert 1/2 inch bolts (OO) through appropriate holes in
cabinet bottom given the sill width distance.Thread the
bolts into the slots of the support brackets.Tighten
locknuts onto bolts.
Left Support Bracket
Angle Bracket (HH)
3/4 inch Flat Head Bolt
and Locknut (NN)
□ Adjust height of sill angle bracket (HH) so that bracket
rests securely on edge of sill, and so that cabinet has
the correct 3° downward tilt for proper water drainage.
Tighten nuts securely.
Window Sash
Window Sill
6
Attach The Top Rail To Window
□ Close window behind top angle rail.
□ Attach the top rail to window sash: Use a drill bit to drill one
hole through the hole in the middle of top rail into the window
sash, and drive one 3/4 inch screw (LL) through the hole in
the middle of top rail into the window sash as shown.
1/2 inch Bolt and Locknut (OO)
Right Support Bracket
About
3°
Side louvers
Angle Bracket (HH)
3/4 inch screw (LL)
7
Attaching Side Curtains to Window
□ Pull the left-hand curtain out until it fits into the window
channel.
□ Use a 1/8 inch (3 mm) drill bit to drill a starter hole through
the hole in the curtain housing .
□ Insert one of the 3/4 inch screw (C) through the left-hand
curtain housing (B) and into the window sash (A).
□ Repeat for the right-hand curtain.
A A
B B
LL
11
Publicidad
