Sea-Bird Scientific HydroCAT-EP V2 Manual Del Usuario página 4

d. Do a check of the optics.
10. Use the "deployment wizard" in the software to set up the sensor for a specific deployment. Refer
to Setup to collect data for details.
• Controlled: (includes SDI-12 operation): On command, operate the pump, collect one data
sample, send data to PC.
• Autonomous: Sensor turns on, the pump operates, data is collected then saved in the sensor,
the sensor goes into a low power mode.
11. If necessary, attach the sensor to the frame it will be deployed on.
12. Make sure to do maintenance on the sensor at regular intervals for best sensor performance.
Refer to Maintenance for details.
Section 2 Specifications
2.1 Mechanical
Rated depth
Weight in air, water
Length
Material
2.1.1 Bulkhead connectors
2.1.1.1 Bulkhead connector
Contact Function
1 Ground
2 RS232 RX
3 RS232 TX
4 SDI-12
5 Reserved
6 Voltage in
4 English
350 m
4 kg, 1.5 kg
72.1 cm
Plastic
MCBH6MP connector