universalblue UBCA2004-21 Manual De Instrucciones página 27

body, then use ST4.2x30 screws (2) to hold the bottom of the
hood.
 Drill 2 holes in the wall and place 2 plasterboard moorings. Use
(2) ST2.9x14 to fix the chimney cover I above, use (2)M3x6 to fix
the chimney cover I below.
 Carefully slide the decorative chimney top down inside the bottom
of the chimney. Carefully place the bottom of the decorative
chimney in the recessed area of the top of the hood body. Drill 2
holes in the wall and place 2 plasterboard moorings (10x45 mm).
Attach the chimney mounting bracket to the wall using (2)
ST4.2X30 screw. Level the hood and hold the chimney with 2 of
the provided M4x6 screws.
 To install the grease filter, align aluminum filter with slots in the
hood. Push in the plastic latch tab, put the filter into position and
release. Make sure the filter is securely engaged after assembly.
INSTALL CHARCOAL FILTER
To remove the grease filter.
27