Publicidad
Idiomas disponibles
Idiomas disponibles
2610067395 GKS18V-26L 08-21.qxp_GKS18-25C 8/5/21 12:39 PM Page 12
Disconnect battery pack from tool before making any assembly, adjustments
or changing accessories. Such preventive safety measures reduce the risk of
starting the tool accidentally.
Inserting and Releasing
Battery Pack
in the battery/charger list, included with
your tool. Using other types of batteries
may result in personal injury or property
damage.
Slide charged battery pack 4 into the
housing until the battery pack locks into
position (Fig. 2).
Your tool is equipped with a secondary
locking latch to prevent the battery pack
from completely falling out of the handle,
should it become loose due to vibration.
To remove the battery pack 4, press the
battery pack release button 5 and slide the
battery pack forward.
Press the battery pack release button 5
again and slide the battery pack completely
out of tool housing (Fig. 2).
Fig. 2
12
Saw Assembly
Use
only
Bosch
batteries recommended
(15)
(26)
(25)
Attaching the Blade
Use
(184mm) blade. Use
only blade rated 5000/min (RPM) or
greater. Using blade not designed for the
saw may result in serious personal injury
and property damage.
1.
Press and hold the shaft lock button 15.
Turn blade stud 11 with provided
wrench 24 in the direction b and remove
blade stud 11 and outer washer 12.
Note: the wrench is stored near the
battery compartment (Fig. 2).
2.
Make sure the saw teeth and arrow on
the blade point in the same direction as
the arrow on the lower guard.
3.
Retract the lower guard all the way up
into the upper guard. While retracting
the lower guard, check operation and
condition of the LOWER GUARD
SPRING.
(4)
(14)
(13)
(12)
b
a
only
7-1/4"
(24)
(11)
Publicidad
