Publicidad
Idiomas disponibles
Idiomas disponibles
HDC200 Operating Instructions
Disconnect the plug from
the power source before
making
any
assembly,
changing accessories. Such preventive safe-
ty measures reduce the risk of starting the
tool accidentally.
The HDC200 Bosch dust extraction attach-
ment is designed to be used in drilling appli-
cations in concrete and masonry type materi-
als. Not for use on wood or metal materials.
The HDC200 is optimized for use with drill
bit diameters from 1/4" to 1-3/8". The maxi-
mum bit diameter is 2-5/8" (brush ring must
be removed for diameters larger than 1-3/8").
Insert the dust extractor hose from the dust
extractor into the dust port of the dust ex-
traction unit (Fig. 9).
FIG. 9
Dust
extraction
unit
Dust
port
Snap-in
connector
The Bosch dust extractor hose comes with a
sleeve nozzle attached to a snap-in connec-
tor. The sleeve nozzle provides the quickest
and easiest connection of the nozzle to the
attachment. The snap-in connector provides
a more secured connection. To use the snap-
in connector, remove the rubber nozzle from
the dust extractor hose. Press the snap-in
connector into the dust port until you hear
the click.
GFA12-H manual DRAFT 20220121.indd 12
Dust Extraction
adjustments
Brush
Sleeve
ring
nozzel
connector
Dust
extractor
Dust port adaptors are also available to con-
nect the Bosch dust extraction attachment
to any common size dust extractor hose. See
Boschtools.com for details.
or
Turn the dust extractor on and place the at-
tachment on the wall (or the floor), over the
desired drilling location so that the center of
the hole lines up with the center of the open-
ing of the brush ring.
Note: the suction from the dust extractor will
hold the attachment in place on the work sur-
face.
Place the drill bit through the opening in the
brush ring in the desired drilling location and
drill the desired hole (Fig. 10). Follow all tool
safety and operating instructions.
FIG. 10
Note: for best results, continue running the
tool even when removing the bit from the
hole. The combination of the vacuum with
the spinning motion of the bit helps remove a
majority of the dust from the hole.
-12-
1/27/22 8:08 AM
Publicidad
