Publicidad
Idiomas disponibles
Idiomas disponibles
B
Program
6
indicator
Delay
7
To show the delay time (3h/6h/9h/12h).
time
Water softener
• The water softener must be set manually, using the water hardness dial.
• The water softener is designed to remove minerals and salts from the water, which would
have a detrimental or adverse effect on the operation of the appliance.
• The more minerals there are, the harder your water is.
• The softener should be adjusted according to the hardness of the water in your area.
• Your local Water Authority can advise you on the hardness of the water in your area.
Adjusting salt consumption
• The dishwasher is designed to allow for adjustment in the amount of salt consumed based
on the hardness of the water used. This is intended to optimise and customise the level of
salt consumption.
• Please follow the steps below for adjustment in salt consumption.
1. Open the door, switch on the appliance;
2. Within 60 seconds after the appliance was switched on press the Program button for more
than 5 seconds to enter the water softener setting mode.
3. Press the Program button again to select the proper set according to your local
environment, the setting will change in the following sequence: H1->H2->H3->H4->H5->H6;
4. Press the Power button to end the setting mode.
Using the appliance
Intensive
Heavily soiled items include pots and pans. With dried
on food.
ECO
This is the standard program suitable for normally
soiled loads, such as pots, plates, glasses and lightly
soiled pans.
90 min
For normally soiled loads that need quick wash.
Rapid
A shorter wash for lightly soiled loads that do not
need drying.
23
EN
Publicidad
