Vega VEGAFLEX 82 Instrucciones De Servicio página 76

11 Anexo
FF desciptor
PRIMARY_VALUE
PRIMARY_VALUE_UNIT
SECONDARY_VALUE_1
SECONDARY_VALUE_1_
UNIT
SECONDARY_VALUE_2
FILL_HEIGHT_VALUE
FILL_HEIGHT_VALUE_UNIT
CONST_VALUE
SECONDARY_VALUE_1_
TYPE
SECONDARY_VALUE_2_
TYPE
FILL_HEIGHT_VALUE_Type
DIAGNOSIS
DIAG_MASK_1
DIAG_OUT_1
DIAG_MASK_2
DIAG_OUT_2
DEVICE_IDENTIFICATION
DEVICE_NAME
IS-SPARE_ELECTRONICS
DEVICE_VERSION_INFO
CALIBRATION_DATE
FIRMWARE_VERSION_ASCII Software version
HW_VERSION_ASCII
ADJUSTMENT_DATA
FIRMWARE_VERSION_MAIN Software versions major, minor, revision and build
PHYSICAL_VALUES
DEVICE_UNITS
APPLICATION_CONFIG
LINEARIZATION_TYPE_SEL
76
Description
PRIMARY_VALUE (Linearized value). This is the process va-
lue after min/max adjustment and Linearization with the status
of the transducer block. The unit is defined in "PRIMARY_VA-
LUE_UNIT"
Selected unit code for "PRIMARY_VALUE"
This is the measured value after min/max adjustment with the
status of the transducer block. The unit is defined in "SECON-
DARY_VALUE_1_UNIT"
Selected unit code for "SECONDARY_VALUE_1"
This is the distance value ("sensor_value") with the status of
the transducer block. The unit is defined in "SECONDARY_VA-
LUE_2_UNIT"
Filling height. The unit is defined in "FILL_HEIGHT_VALUE_
UNIT"
Filling height unit
Constant value
Secondary value 1 type
Secondary value 2 type
Filling height value type
AITB Diagnosis
Manufacturer ID, device type, bus type ID, measurement princi-
ple, serial number, DTM ID, device revision
Device name
Device name
Hard- and software version for system, function and error
Day, month and year
Hardware version
Min./max.-adjustment physical, percent and offset
Distance, distance unit, distance status, level and status
Distance and temperature units of the instrument
Medium type, media, application type, vessel bottom, vessel
height
Type of linearization
Unit
VEGAFLEX 82 • Foundation Fieldbus