Serial 1 BASH Manual Del Propietário página 19

Screw a circular locking nut into
o
the slot, tightening using multi-
tool
14. Install spoke reflectors (Method 2)
Wrap a plastic clamp around a
o
spoke
Fit clamp to the end of a reflector
o
Screw the pieces together,
o
tightening using multi-tool
Torque Specifications
Always tighten fasteners to the correct
torque to ensure the integrity of the
eBicycle. In case of a conflict between this
manual and information provided by a
component manufacturer, consult with
Serial 1 or the component's customer
service representatives for clarification.
Table 3: Torque Values
Tool
Part Torque
Size
4mm
Tighten bottom two,
Handlebar 6 Nm
⬡
then top two screws
Handlebar 4mm If necessary, for
6 Nm
⬡
stem
5mm
Saddle rail If necessary, for
16 Nm
⬡
clamp
Seatpost 4mm Set the height, then
6 Nm
⬡
clamp
Align brake disc
Axles
6mm rotor between brake
11 Nm
⬡
pads before inserting
(wheels)
FIT
Verify your eBicycle is the correct size.
Correct fit is essential for a safe and
pleasant ride.
Notes
service
service
torque
axle
13