Publicidad
Idiomas disponibles
Idiomas disponibles
EN
When cutting a limb that is under
tension, be alert for springback
so that you will not be struck by
the moving limb. Always stop the
engine immediately and check
for damage if you strike a foreign
object or if the machine becomes
tangled. Do not operate with
broken or damaged equipment.
IMPORTANT
Do not make unauthorized
modifications or substitutions to the
guide bar or chain.
Never allow the engine to run at
high RPM without a load. Doing so
could damage the engine.
Keep the pruner as clean as
possible
5. SET UP
MOUNTING ENGINE
1. Push the shaft tube toward the
clutch housing and rotate it by
hand to check that the drive shaft is
engaged with the gears.
2. Insert the shaft tube into the
clutch housing until it bottoms, and
align the positioning holes on the
clutch housing and the shaft tube
and install the screw. When difficult
to engage, twist the engine slightly.
3. Fasten the clamp securely with
two screws.
IMPORTANT
Tighten the screws gradually by
turns.
46
CONNECTING
THROTTLE WIRE
1. Remove the air cleaner cover.
2. Connect the end of the throttle
wire to the joint on the top of the
carburetor.
M3 screw
Adjuster
Insert the cable
to the end
of adjuster
Full on stopper
Idling adjust screw
1. Connect the throttle cable to the
carburetor. Insert the cable until the
end of the adjuster, fix the throttle
cable by tightening the M3 screw.
(Tightening torque: 0.4-0.8 N.m.)
2. Make sure the carburetor plate
moves to contact the adjusting
screw.
CONNECTING
SWITCH WIRES
Connect the switch wires between
the engine and the main unit. Pair
the wires of the same color.
SUSPENSION POINT
NOTE: Be the SUSPENSION POINT
in the location of the arrow mark.
Suspension
Point
arrow mark
INSTALLING HANDLE
NOTE: The handle is put during
the arrow mark.
Min.
space
Mount the handle to the shaft tube
and suspension point it at a location
that is comfortable to you.
Insert the grip to the shaft tube.
Fasten the clamps with screws.
Install the J-shaped handle to the
shaft tube and clamp at a position
best for your job.
JOINT ATTACHMENT
knob bolt
Insert the attachment to the main
shaft. ighten the knob bolt securely.
Publicidad
