Descargar Imprimir esta página

Beper P206VEN131 Manual De Instrucciones página 11

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 23
Stand Fan with Remote Control Use Instructions
Description of the item
1. Front grid
2. Grid blocking clips
3. Blade blocking nut
4. Blade
5. Grid blocking nut
6. Back grid
7. Motor shaft
8. Motor
9. Tilt adjusting pin
10. Control panel
11. Pole blocking screw
12. Telescopic pole
13. Pole adjusting and blocking screw
14. Outer pole
15. Standing base
16. L­shape screw for base with washer
Assembling Fig. A
Make sure to place the base on a flat and stable surface. Proceed as shown in fig. A (from a to g).
Important: make sure all components are well fixed, to avoid dangerous vibrations during operation.
If the telescopic pole is not visible from the outside, it might be fully inserted inside the outer pole – take it out
and adjust it to the desired height.
Operation Fig.B
Connect the fan to a wall socket. Press ON/speed key to switch the fan on and to select the desired fan
speed.
It is possible to choose the fan mode by pressing the mode key:
Normal: the fan works at constant speed
Nature: the fan alternates all three speeds to recreate a natural breeze
Sleep: the fan runs at maximum speed for a few minutes, then passes to medium speed and finally to mini­
mum speed.
Press the swing mode key to activate this function; press it again to deactivate the swing mode.
It is possible to set the automatic switching off of the fan; press the timer key until the desired time is set
(from 0,5h to 7,5 h): the relevant LED indicator lights up on the control panel (if for example you wish to set
the automatic switching off after 2 hours, press the timer key until the relevant LED indicator lights up on the
control panel; if you wish to set the automatic switching off time after 7,5 hours, then press the timer key until
all LED indicators on the control panel light up).
To adjust the tilt angle, rotate the tilt adjusting pin counter clockwise as shown in fig.B.
Warning: tilt the head only when the fan is switched off; do not force the tilt movement, to avoid
damaging the tilting mechanism.
To switch the fan off, press the OFF key.
Cleaning and maintenance
Before carrying out any cleaning operation, switch the fan off and unplug it from the wall socket.
To clean the fan use a soft cloth, slightly dampened with water if needed.
Do not use alcohol or chemical agents such as diluents, or abrasive detergents in general
Do not spray water or other liquids on the fan, to avoid dangerous infiltrations.
Dry thoroughly all parts and components before switching the fan on.
When the fan is not used for a long period of time, store it in a dry and clean place.
17. Central disc
18. Central disc blocking screw
19. Grid blocking screw
20. Grid blocking bolt
21. Remote controller
22. LED indicator for sleep mode
23. LED indicator for normal mode
24. LED indicator for nature mode
25. High speed LED indicator
26. Medium speed LED indicator
27. Low speed LED indicator
28. Swing mode key
29. Mode key
30. Timer key
31. ON/speed key
32. OFF key
11
EN

Publicidad

loading