Descargar Imprimir esta página

Husqvarna Aspire LC34-P4A Manual De Usuario página 14

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 142
service agent. Speak to your nearest service agent
for more information.
Do the maintenance work correctly to increase the
lifetime of the product and decrease the risk of
accidents.
Replace damaged, worn or broken parts. Always use
original spare parts from the manufacturer. Other
spare parts can cause damage to the product and
increase the risk of accidents.
To prevent injury, do not remove or do modifications
to safety devices.
Put on heavy duty gloves when you use the cutting
equipment. The blade is very sharp and cuts can
easily occur.
Introduction
WARNING:
product, read the safety chapter.
WARNING:
during assembly, turn the safety key to 0,
remove the battery and wait at minimum 5
seconds.
To adjust the handle height
The product has free handle height adjustment span.
The handle height can be set to a applicable height
between 2 set points.
1. Set the product in operation position. Refer to
the product in operation position on page 15 .
2. Turn the lock knobs on the handlebars
counterclockwise. (Fig. 27)
3. Pull the handlebars to a suitable position.
4. Put the 2 handlebars in level.
CAUTION:
in level, the product will be damaged.
5. Turn the lock knobs on the handlebars clockwise.
6. Tighten the lock knobs fully.
To install the grass catcher
1. Lift the rear cover.
2. Remove the mulch plug.
14
Assembly
Before you assemble the
To prevent accidental start
To set
If the handlebars are not
Keep the cutting edges sharp and clean for the best
and safest performance.
Let your service agent regularly examine the product
and make necessary adjustments and repairs.
Obey the instructions for how to change accessories.
Only use accessories from the manufacturer.
When not in operation, keep the product, battery and
battery charger apart in a dry, indoor and locked
area. Make sure that children and persons that are
not approved cannot get access to the product,
battery or battery charger.
3. Attach the grass catcher to the top edge of the
chassis.
4. Put the lower part of the grass catcher against the
grass discharge channel. (Fig. 28)
CAUTION:
grass catcher is sealed correctly to the
chassis of the product.
To install the mulch plug
1. Lift up the rear cover and remove the grass catcher.
2. Push the mulch plug into the discharge channel until
you hear a click. (Fig. 29)
To install the hook on the wall
Install the hook indoors.
Keep the hook out of sunlight and in ambient
temperature of -10 °C to +70 °C.
Install the hook on a drywall, wood or concrete wall.
CAUTION:
can hold loads of minimum 30 kg.
Install the hook on the wall with the 3 screws (A).
Use wall plugs (B) if it is necessary. (Fig. 30)
CAUTION:
screws are applicable for your wall type.
Speak to your Husqvarna service agent for
information about available storage accessories for
your product.
Make sure that the
Make sure that the wall
Make sure that the
1848 - 004 -

Publicidad

loading