Husqvarna Aspire LC34-P4A Manual De Usuario página 20

Problem Error LED (number
of flashes)
Error LED flashes. 22
The product stops.
0
3
9
8
12
Other errors. If other errors occur, turn the safety key to 0, remove the battery and speak to an approved
service agent.
Introduction
WARNING:
during transport and storage turn the safety
key to 0, remove the battery and wait a
minimum of 5 seconds.
To set the product in transport position
1. Remove the grass catcher and make sure that the
grass catcher is empty.
2. Turn the lock knobs on the handle counterclockwise
to unlocked position. (Fig. 45)
3. Push the handle in the direction of the rear cover.
4. Turn the lock knobs on the handle clockwise to
locked position.
20
Cause
The battery temperature is too
high because the temperature
in the work environment is too
high.
The battery temperature is too
high because there is over-
load in the motor
Battery connector failure.
There is overload in the mo-
tor.
Battery error or no signal from
battery.
The battery is weak.
Incorrect start procedure. The
motor brake handle has been
engaged before the motor
starts.
Transportation, storage and disposal
To prevent accidental start
Solution
Remove the battery from the machine
and wait for it to cool down before start-
ing the machine again. Make sure that
the ambient temperature is correct. Use
the battery in temperatures between 0°C
- +40°C. If the problem continues, speak
to an approved service agent.
Increase the cutting height. Refer to
set the cutting height on page 15 . If
the problem continues, speak to an ap-
proved service agent.
Examine the battery connector.
Increase the cutting height. Refer to
set the cutting height on page 15 .
Put the battery in the product correctly
and examine the battery connector. If the
error LED on the battery flashes, refer
Troubleshooting of the battery charger
to
on page 18 . If the problem continues,
speak to an approved service agent.
Charge the battery. Refer to
the battery on page 15 .
Release the motor brake handle and
wait approximately 5 seconds. Push the
motor brake handle down again to start
the product.
5. Turn the handle knobs to the unlocked position. (Fig.
46)
6. Fold the handle down until you hear a click. (Fig. 47)
To set the product in storage position on page
Refer to
21 to store the product.
Transportation
• The Dangerous Goods Legislation requirements
apply to the contained Li-ion batteries.
• For commercial transports special requirements on
package and labels must be obeyed.
• Make sure that you obey the regulations for
dangerous material when you prepare the product
for transport. Local regulations can apply.
• Always remove the battery for transport.
To
To
To charge
1848 - 004 -