Publicidad
Idiomas disponibles
Idiomas disponibles
You can proceed with the Wi-Fi set-up in this tab. If you are using ethernet, you don't need to
set up that tab, so immediately click the 'Next' button to move to the next tab.
1. Continent: Select continent
2. Time zone:Hour: Select time-zone(with detailed area)
3.
selected, operation is possible at all times). It is initialized when power on reset.
4. Operating mode: Set the RMD data transfer mode. Normal mode is 'With BMS'.
'Without BMS' is debugging mode, and 'Update only mode' is update only mode.
5. Server use: Select the server enable or disable.
6. IoTHub connection string: Paste the connection string copied earlier.
(The string format:
)
7. Click the 'Save' & 'Complete' button. So, the web page moves to the 'Monitoring
– Status' tab where you can check the installation status.
27
1. Click the scan AP button on the top right
of the Web UI.
2. The number of APs available is displayed
in a pop-up window.
3. Select the AP to access from the SSID
combo box, enter the password and
click the connect button(Manual input is
possible).
4. If the connection to the AP is successful,
a pop-up window informs whether the
connection was successful as follows:
5. Click the 'Next' button.
7.2.3.7 Check the Installation Status
After completing the installation process, you can check whether the installation is normal as
follows.
- BMS operation mode: Normal/Running
- Server connection: OK
Publicidad
