Publicidad
Idiomas disponibles
Idiomas disponibles
Electrical Installation
All installation must be carried out by a competent person or qualified electrician. Before connecting the
mains supply ensure that the mains voltage corresponds to the voltage on the rating plate.
Direct Connection
This appliance must be connected directly to the mains using an omnipolar circuit breaker with a minimum
opening of 3 mm between contacts.
The installer must ensure that the correct electrical connection has been made and that it complies with the
wiring diagram.
The cable must not be bent or compressed.
Regularly check the power plug and power cord for damage. If the supply cord is damaged, it must be
replaced by a special cord or assembly available from the manufacturer or its service agent.
WARNING: THIS IS A CLASS I APPLIANCE AND MUST BE EARTHED.
This appliance is supplied with a 3 core mains cable coloured as follows:
Brown = L or Live
Blue = N or Neutral
Green and Yellow = E or Earth
This appliance should be connected directly to the consumer unit with a 20 Amp Residual Current
Device (RCD) protecting its circuit.
To avoid the risks that are always present when you use an electrical appliance it is important that this
appliance is installed correctly and that you read the safety instructions carefully to avoid misuse and
hazards. Please keep this instruction booklet for future reference and pass it on to any future owners.
After unpacking the appliance please check that it is not damaged. If in doubt, do not use the appliance but
contact Customer Services - see end of Care & maintenance section for details.
Technical data
Item
Model identification
Supply voltage
Maximum power
Volume per cavity
5059340350882_MNL_IN_V06.indb 49
5059340350882_MNL_IN_V06.indb 49
Symbol
Value declared
GHCPO45
220-240 V~ 50 Hz
V
49
3350 W
44
Unit
L
05-08-2022 15:11:43
05-08-2022 15:11:43
Publicidad
