IKEA VAPPEBY Serie Manual De Instrucciones página 12

The speaker will enter Bluetooth pairing mode
automatically the first time it is powered on, and any
time that a previously paired device cannot be found.
Factory reset
To remove previous Bluetooth pairings, reset the
speaker by pressing and holding the button (1) for more
than 5 seconds. Successful factory reset is confirmed by
the LED flashing red and with an audible sound.
Alternatively, go to the Bluetooth menu on your source
device and unpair.
Stereo pairing:
Two VAPPEBY Portables can be stereo paired:
1. M ake sure both speakers are in Bluetooth search
mode.
2. D ouble-press the power button on one of the
speakers. A sound will confirm successful stereo
pairing.
3. C onnect to the source device by following the
Bluetooth pairing instructions.
Good to know
• The speaker is suitable for outdoor use, protected
against dust and water according to IP67.
• If the speaker's front protection is soaked with water,
acoustic performance may be affected temporarily, but
it will go back to normal once the water is gone.
• Devices and the battery may get warm during
charging. This is completely normal, and they will
gradually cool down again after they are fully charged.
12