Andis FS-1 Instrucciones De Uso Y Cuidado página 7

TO REPLACE FOIL ASSEMBLY
1. Remove the foil assembly by pressing the round assembly lock button located on
the right side of the shaver. Grasp the foil assembly on both sides and gently lift it
off the shaver (Figure B).
2. Position the replacement foil assembly over the cutters. Be careful not to damage
the foils. Gently slide the foil assembly down until it snaps firmly into place.
TO REPLACE CUTTERS
NOTE: Always replace the foil assembly when replacing the cutters.
1. To remove a cutter, grasp it on both sides and pull up (Figure C).
2. To replace a cutter, hold it on both sides and line up the small metal shaft on its
underside with the notch on the shaver drive and push down firmly until it snaps
into place.
3. Replace foil assembly.
CLEANING
Regular cleaning is necessary in order to maintain the optimal performance and
maximum comfort from your shaver. Do NOT run shaver, foil assembly or cutters
under water. Use only the small brush (included) to clean.
DRY CLEANING WITH BRUSH
1. Remove the foil assembly by pressing the round button located on the right side
of the unit. Grasp the foil assembly on both sides and gently lift it off of the shaver
(Figure B).
2. Gently tap the base of the foil assembly on a flat surface so that the hairs inside fall
out. Do not remove the individual foils or they may be damaged accidentally.
3. Lightly brush the hairs out from the cutters. You can remove them from the shaver
if necessary (Figure C). Blow out any remaining loose hairs.
4. Replace the cutters and foil assembly.
7