Switch Action - Makita JR3060T Manual De Instrucciones

NOTE:
Orbital action means that the saw blade moves up
•
and down, and back and forth at the same time.
This increases the efficiency of cutting.
Position Cutting action
0
Straight line cutting action
I
Small orbit cutting action
Medium orbit cutting
II
action
Large orbit cutting
III
action
002525

Switch action

1
006185
CAUTION:
Before plugging in the tool, always check to see
•
that the switch trigger actuates properly and
returns to the "OFF" position when released.
For Model JR3060T, JR3070CT
CAUTION:
Switch can be locked in "ON" position for ease of
•
operator comfort during extended use. Apply
caution when locking tool in "ON" position and
maintain firm grasp on tool.
To start the tool, simply pull the switch trigger. Tool
speed is increased by increasing pressure on the switch
trigger. Release the switch trigger to stop.
For continuous operation, pull the switch trigger and
then push in the lock button.
To stop the tool from the locked position, pull the switch
trigger fully, then release it.
For Model JR3070CTZ
To start the tool, simply pull the switch trigger. Tool
speed is increased by increasing pressure on the switch
trigger. Release the switch trigger to stop.
Applications
For cutting mild steel, stainless
steel and plastics.
For clean cuts in wood and
plywood.
For cutting mild steel, aluminum
and hard wood.
For cutting wood and plywood.
For fast cutting in aluminum and
mild steel.
For fast cutting in wood and
plywood.
1. Switch trigger
2
2. Lock button
Speed adjusting dial
(For JR3070CT, JR3070CTZ)
1
006025
The strokes per minute can be adjusted just by turning
the adjusting dial. This can be done even while the tool
is running. The dial is marked 1 (lowest speed) to 6 (full
speed). Turn the adjusting dial without positive stops
between 1 and 6 according to your work.
Refer to the table to select the proper speed for the
workpiece to be cut. However, the appropriate speed
may differ with the type or thickness of the workpiece. In
general, higher speeds will allow you to cut workpieces
faster but the service life of the blade will be reduced.
Number on adjusting dial
6
5
4
3
2
1
006574
Workpiece to be cut
Wood
Autoclaved lightweight concrete
Mild steel
Aluminum
Plastics
Stainless steel
006584
NOTE:
If the tool is operated continuously at low speeds
•
for a long period of time, the operation life of the
motor will be reduced.
The speed adjusting dial can be turned only as far
•
as 6 and back to 1. Do not force it past 6 or 1, or
the speed adjusting function may no longer work.
The tools equipped with electronic function are easy to
operate because of the following features.
Constant speed control
Electronic speed control for obtaining constant speed.
Possible to get fine finish, because the rotating speed is
kept constant even under load condition.
Soft start feature
Safety and soft start because of suppressed starting
shock.
5
1. Adjusting dial
Strokes per minute
2,800
2,500
1,850
1,400
1,000
950
Number on adjusting dial
6
5 - 6
3 - 4
3 - 5
1 - 4
1 - 2