Publicidad
Idiomas disponibles
Idiomas disponibles
effect of "repair or replace as necessary" shall advise owners of the
warranty coverage for emissions related parts. Replacement within
the warranty period is covered by the warranty and will not reduce
the period of warranty coverage. Any such part repaired or replaced
under warranty must be warranted for the remaining warranty period.
(3) Any warranted part that is scheduled for replacement as required
maintenance in the written instructions must be warranted for the
period of time prior to the first scheduled replacement point for that
part. If the part fails prior to the first scheduled replacement, the part
must be repaired or replaced by DJI according to Subsection (4)
below. Any such part repaired or replaced under warranty must be
warranted for the remainder of the period prior to the first scheduled
replacement point for the part.
(4) Repair or replacement of any warranted part under the warranty
provisions must be performed at no charge to the owner at a warranty
station.
(5) Notwithstanding the provisions of Subsection (4) above, warranty
services or repairs must be provided at distribution centers that are
franchised to service the subject engine/equipment.
(6) The owner must not be charged for diagnostic labor that leads to the
determination that a warranted part is in fact defective, provided that
such diagnostic work is performed at a warranty station.
(7) DJI is liable for damages to other engine/equipment components
proximately caused by a failure under warranty of any warranted part.
(8) Throughout the emissions control system's warranty period set out
in subsection (b)(2), DJI must maintain a supply of warranted parts
sufficient to meet the expected demand for such parts and must
obtain additional parts if that supply is exhausted.
(9) Manufacturer-approved replacement parts that do not increase
the exhaust or evaporative emissions of the engine or emissions
control system must be used in the performance of any warranty
maintenance or repairs and must be provided without charge to the
owner. Such use will not reduce the warranty obligations of DJI.
(10) Add-on or modified parts that are not exempted by the Air Resources
Board may not be used. The use of any non-exempted add-on or
modified parts will be grounds for disallowing a warranty claim. DJI
will not be liable to warrant failures of warranted parts caused by the
use of a non-exempted add-on or modified part.
(11) DJI issuing the warranty shall provide any documents that describe
that warranty procedures or policies within five working days of
request by the Executive Officer.
(d) Emission Warranty Parts List for Exhaust
(1) Fuel Metering System
(i)
Carburetor and internal parts (and/or pressure regulator or fuel
injection system).
(ii)
Air/fuel ratio feedback and control system.
(iii) Cold start enrichment system.
(2) Air Induction System
(i)
Controlled hot air intake system.
(ii)
Intake manifold.
(iii) Air filter.
(3) Ignition System
(i)
Spark Plugs.
(ii)
Magneto or electronic ignition system.
(iii) Spark advance/retard system.
(4) Exhaust Gas Recirculation (EGR) System
(i)
EGR valve body, and carburetor spacer if applicable.
(ii)
EGR rate feedback and control system.
(5)
Air Injection System
(i)
Air pump or pulse valve.
(ii)
Valves affecting distribution of flow.
(iii) Distribution manifold.
(6) Catalyst or Thermal Reactor System
(i)
Catalytic converter.
(ii)
Thermal reactor.
(iii) Exhaust manifold.
(7) Particulate Controls
(i)
Traps, filters, precipitators, and any other device used to capture
particulate emissions.
(8)
Miscellaneous Items Used in Above Systems
(i)
Electronic controls.
(ii)
Vacuum, temperature, and time sensitive valves and switches.
(iii) Hoses, belts, connectors, and assemblies.
(e) Emission Warranty Parts List for Evap
(1) Fuel Tank
(2) Fuel Cap
(3) Fuel Lines (for liquid fuel and fuel vapors)
(4) Fuel Line Fittings
(5) Clamps*
(6) Pressure Relief Valves*
(7) Control Valves*
(8) Control Solenoids*
(9) Electronic Controls*
(10) Vacuum Control Diaphragms*
(11) Control Cables*
(12) Control Linkages*
(13) Purge Valves*
(14) Gaskets*
(15) Liquid/Vapor Separator
(16) Carbon Canister
(17) Canister Mounting Brackets
(18) Carburetor Purge Port Connector
* Note: As they relate to the evaporative emission control system.
DJI will furnish with each new small off-road engine/equipment written
instructions for the maintenance and use of the engine/equipment by the
owner.
139
Publicidad
