DJI D6000i Guía De Usuario página 7

Operation Panel
1
2
3
Status LEDs
1
2
3
Status LED Blinking Pattern
Solid yellow
Blinks green once continuously
Charging Channel
Solid green
Status LED
Blinks yellow once continuously
Blinks red once continuously
Blink yellow four times continuously
DC Module Status
Blinks yellow once continuously
LED
Blinks red once continuously
Blink yellow four times continuously
Generator (excl. DC
Blinks yellow once continuously
Module)/AC Module
Blinks red once continuously
Status LED
Blinks red four times continuously
• When the status LEDs blink indicating a warning or error, connect the USB-C connector of the generator to the USB-A
connector of the remote controller using a USB-C cable. Run the DJI AGRAS™ app on the remote controller and
check the specific warnings or errors on the charging device interface.
• When the status LED blinks prompting for maintenance, connect the USB-C connector of the generator to the USB-A
connector of the remote controller using a USB-C cable. Run the DJI Agras app on the remote controller and check
the specific maintenance information on the charging device interface. When maintenance is finished, press the reset
button on the charging device interface to turn off the status LED blinking for maintenance.
• If any part of the generator is abnormal or damaged, it is recommended to contact a DJI-authorized dealer or DJI
Support to repair or replace the part.
6
ENG.SW.
START
ON
OFF
4
1. Engine Switch
Used to start or stop the generator. Refer to the Using
the Generator section for more detailed information.
2. AC Outlet*
Used to connect with electric devices. The outlet
meets the IP44 protection rating. Make sure to reinstall
and fasten the outlet shield when not in use.
* The AC power output of the generator may differ depending
on your country and region. Refer to the Appendix section
for details.
3. Ground Terminal
Use a ground cable and connect one end to the
ground terminal and the other end to the ground.
Proper grounding can help to avoid electric shocks in
case of device failure.
1. Charging Channel Status LED
2. DC Module Status LED
3. Generator (excl. DC Module)/AC Module Status LED
4. USB-C Connector Cover
Description
The generator is ready to connect to a battery
Charging
Fully charged
Warning for the battery/charging channel
Battery/charging channel error
DC module is not activated
Warning for the DC module
DC module error
Generator (excl. DC Module)/AC Module is not activated
Warning for the generator (excl. DC Module)/AC Module
Generator (excl. DC Module)/AC Module error
Generator (excl. DC Module) maintenance is required