Descargar Imprimir esta página

Baxi 7802133 Manual De Usuario E Instalacion página 46

Publicidad

Idiomas disponibles

Idiomas disponibles

en
1 Safety instructions and recommendations
1
Safety instructions and recommendations
1.1
General safety instructions
General
Only qualified installer or qualified service person are allowed to carry out the installation. Users are
strictly prohibited to carry out the installation.
For the purpose of easy operation, read this manual carefully and follow its instructions.
Keep the manual carefully for reference.
Only a qualified installer or qualified service person is allowed to carry out the electrical work of the in­
door and outdoor units. Under no circumstances must this work be done by an unqualified individual
since failure to carry out the work properly may result in electric shocks and/or electrical leaks.
The appliance must be installed in accordance with national wiring regulations. Capacity shortages in the
power supply circuit or an incomplete installation may cause an electric shock or fire.
Before cleaning or maintenance, cut off power switch; waterwashing is prohibited, which has the risk of
electric shock.
Pesticides, disinfectants, and flammable spray materials are prohibited for direct spraying; otherwise, it
may cause a fire or the deformation of devices.
Wet hand operation is prohibited, which has the risk of electric shock.
Do not peel off the display panel by hand, which has the risk of electric shock.
The wired controller is low-voltage circuit and must be separated by 500 mm at least to high-voltage cir­
cuit.
Precautions
If a power supply cable comes with the appliance and it turns out to be damaged, it must be replaced by
the manufacturer, its after sales service or persons with similar qualifications in order to avoid danger.
1.2
Liabilities
Manufacturer's liability
Installer's liability
User's liability
46
Danger
Before any wiring work on the electrical circuit, switch off the power supply, check
that no voltage is present and secure the circuit breaker with a circuit breaker lock­
out.
Our products are manufactured in compliance with the requirements of the various Directives appli­
cable. They are therefore delivered with the
ests of the quality of our products, we strive constantly to improve them. We therefore reserve the
right to modify the specifications given in this document.
Our liability as manufacturer may not be invoked in the following cases:
Failure to abide by the instructions on installing the appliance.
Failure to abide by the instructions on using the appliance.
Faulty or insufficient maintenance of the appliance.
The installer is responsible for the installation and initial commissioning of the appliance. The instal­
ler must observe the following instructions:
Read and follow the instructions given in the manuals provided with the appliance.
Install the appliance in compliance with prevailing legislation and standards.
Carry out initial commissioning and any checks necessary.
Explain the installation to the user.
If maintenance is necessary, warn the user of the obligation to check the appliance and keep it in
good working order.
Give all the instruction manuals to the user.
To guarantee optimum operation of the system, the user must follow the instructions below:
Read and follow the instructions given in the manuals provided with the appliance.
Call on a qualified professional to carry out installation and initial commissioning.
Get your installer to explain your installation to you.
Have the required inspections and maintenance carried out by a qualified installer.
Keep the instruction manuals in good condition close to the appliance.
marking and any documents necessary. In the inter­
7802133 - v01 - 21072022

Publicidad

loading