Cleaning, Care & Maintenance - Buffalo DM868 Manual De Instrucciones

Thermal Protection Reset Button
The Buffalo Sous Vide is fitted with thermal
protection device to protect the unit from damage
due to overheating, low water etc. The button is
located on the front of the unit under the plastic
cover. If unit overheats, allow to cool then reset by
removing the cover and pressing the button.
Reset Button
Cleaning, Care &
Maintenance
• Disconnect from power by removing the
plug, allow to cool before any cleaning
and maintenance.
• The unit is fitted with a detachable filter. Clean
the filter after each use.
Detachable Filter
DM868_ML_A5_v6_20180507.indb 5
Cleaning the interior components
1. When the pump discharge volume is lower
significantly, or when the surface of the inside
components has gathered with too much
dirt, the metal cover protecting the interior
components can be removed for cleaning using
the Allen key supplied. Remove the 4 Hex
headed screws positioned on the bottom of the
unit.
Reset Button
Cover
2. Clean the heater and temperature probe gently
with wet cloth. It is recommended to clean the
interior components after every 20 times use
or every 100 hours use.
Temperature Probe
3. Reattach the back cover after cleaning.
Heater
DO NOT use the Sous Vide
without the back cover in place.
UK
5
2018/5/7 15:18