Publicidad
Idiomas disponibles
Idiomas disponibles
" " then press the "
" button to activate the clean function. The unit will start
releasing steam through the froth dispensing tube. Let the cleaning cycle run
until you no longer see any water coming out of the tube, or let the cycle run
until it stops automatically.
4. Dispose of the water in the mug.
5. You can remove the milk reservoir with the lid and store it in the fridge for
later use.
CLEANING THE BREW HEAD, THE PORTA-FILTER AND FILTERS
1. Press the on/off "I/O" switch located on the right side of the unit to the off
position "O" and unplug the power cord from the electrical outlet.
2. Some of the metal parts may still be hot. Do not touch them with your hands
until they have cooled.
3. Remove the porta-filter and discard the coffee grounds or used pod. Wash
both the porta-filter and filter thoroughly with warm soapy water. Make sure
to rinse and dry them well.
NOTE: Do not wash the porta-filters and filters in the dishwasher.
4. Wipe the lower part of the brew head in the unit with a damp cloth or paper
towel to remove any coffee grounds that might have been left.
5. Place the porta-filter (without any filter) back in the brew head in the unit and
lock it in place.
6. Place a large empty cup under the porta-filter.
7. Plug the power cord into the electrical outlet. Press the on/off "I/O" switch to
the on position "I". Press the Espresso "
with water until it stops automatically.
CLEANING THE WATER RESERVOIR
1. Dispose of the remaining water by removing the water reservoir and turning
it upside down over the sink. It is recommended to empty the water reservoir
between uses.
2. Wash the water reservoir and its lid thoroughly with warm soapy water. Make
sure to rinse and dry them well.
NOTE: Do not wash the water reservoir or its lid in the dishwasher.
CAUTION: Do not immerse main body of the appliance or power cord and
plug in water or any other liquid.
CLEANING THE UNIT
1. Wipe housing with a soft wet cloth. Do not use abrasive cleaners or scouring
pads, as they will scratch the finish.
2. Do not store any of the porta-filters in the brew head. This can adversely affect
the seal between the brew head and the porta-filter while brewing espresso.
DESCALING
Build-up of mineral deposits in the unit will affect the operation of the
18
BVMC-ECM-PMPAT_22ESM2 (US).indd 18-19
BVMC-ECM-PMPAT_22ESM2 (US).indd 18-19
" button once and let the unit brew
appliance. Your appliance must be descaling when you begin to notice an
increase in the time required to brew espresso, or when there is excessive
steaming. Also, you may notice a build-up of white deposits on the surface of
the brew head.
The frequency of cleaning depends upon the hardness of the water used. The
following table gives the suggested cleaning intervals.
SUGGESTED CLEANING INTERVALS
Type of Water
Cleaning Frequency
Soft Water (Filtered Water)
Every 80 Brew Cycles
Hard Water (Tap Water)
Every 40 Brew Cycles
TO DESCALE WATER RESERVOIR:
1. Fill the reservoir with fresh, undiluted white household vinegar.
2. Allow appliance to sit overnight with the vinegar solution in the water
reservoir.
3. Discard vinegar by removing the reservoir and turning it upside down over
the sink.
4. Rinse the water reservoir thoroughly with tap water by filling the tank half full
with water and then pouring the water back out into the sink, repeating this
step twice.
TO DESCALE INTERNAL PARTS:
1. Make sure you descale the inside of the water reservoir first by following the
descale steps above.
2. Make sure to switch the on/off button to the off "O" position and the power
cord is disconnected from the electrical outlet. Fill the reservoir with undiluted
white household vinegar.
3. Insert the porta-filter (with filter and no coffee) and place a large empty cup
on top of the drip tray and under the porta-filter.
4. Plug the power cord into the electrical outlet.
5. Press the on/off button to switch the unit on (I), the control panel progress
bar will illuminate (Espresso heater and Steam heater " " ) showing the
progress. Once the progress bar is a fully illuminated and a solid light, press
the automatic espresso button "
" twice (2). The vinegar will start flowing,
allow to fill a cup, then stop by pressing the button again. The progress bar
illumination will cycle whilst operating.
6. Place a large empty cup (with at least 325 mL/ 11 fl. oz. capacity) under the
frothed milk dispensing tube. Fill the milk reservoir with water and place it
back on the unit. Turn the Froth Control Knob counter clockwise to the clean
position " " then press the Clean "
Let the cleaning cycle run until you no longer see any milk coming out of the
" button to activate the clean function.
2022/4/8 9:31 AM
2022/4/8 9:31 AM
19
Publicidad
