Publicidad
Idiomas disponibles
Idiomas disponibles
FILLING THE MILK RESERVOIR
If you plan to prepare a cappuccino or latte, remove the milk reservoir from the
unit by lifting up on the milk reservoir release button, simultaneously sliding
milk reservoir out (see figure 2). Then, pour the desired quantity of cold milk
you estimate you will need, making sure it is below the "MAX" level on the
reservoir (see figure 3). Once finished, slide the milk reservoir back onto the
unit ensuring it fits tightly. You should feel the milk reservoir lock in place.
Figure 2
NOTE: You can use any type of milk you prefer, i.e. whole milk, low fat milk,
organic or soy milk.
USING THE PORTA-FILTER FOR GROUND COFFEE AND E.S.E PODS
CHOOSING THE FILTER
Select the filter to be used as follows:
a. FOR A SINGLE SHOT – use the filter for a single shot of espresso if using
ground coffee, or if using E.S.E. (Easy Serving Espresso) pods.
b. FOR A DOUBLE SHOT OR TWO SINGLE SHOTS – use the filter for a double
shot of espresso. By placing two small cups underneath the porta-filter, you
may prepare two single shots of espresso at once.
10
BVMC-ECM-PMPAT_22ESM2 (US).indd 10-11
BVMC-ECM-PMPAT_22ESM2 (US).indd 10-11
Figure 3
POD
PLACING THE FILTER ON THE PORTA-FILTER
1. Insert the filter into the porta-filter, making sure to align the filter dimple to
the porta-filter notch (see figure 4).
2. Turn the filter to the left or right to lock it in place (see figure 5).
Figure 4
NOTE: To remove the filter for cleaning, turn the filter to the left or right to
align the filter dimple to the porta-filter notch and proceed to remove.
WARNING: Make sure the filter has cooled down before attempting to remove
it from the porta-filter.
FILLING WITH COFFEE
FOR GROUND COFFEE:
a. Fill the filter with fresh, fine ground espresso coffee about 3mm from the rim
(DO NOT overfill).
b. Using the tamping part of the scoop, push the coffee grounds downwards
as far as the tamper will go to get your espresso grounds compact and
even.
c. Clean any excess coffee from the rim to ensure proper fit under brew head.
a.
b.
FOR E.S.E. (EASY SERVING ESPRESSO) PODS
Simply place the pod in the filter for a single shot of espresso. If there is any
loose paper from the pod sticking out from the filter, be sure to fold it inside to
ensure a good seal when brewing.
POD
Figure 5
c.
2022/4/8 9:31 AM
2022/4/8 9:31 AM
11
Publicidad
