Descargar Imprimir esta página

Dometic 3LION L-20 Instrucciones De Montaje Y De Uso página 15

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 56
EN
NOTICE! Damage hazard
• To prevent damage to the equipment, deactivate all loads and the charger before battery installa-
tion.
• Battery cables must not be connected to the battery in reverse polarity, otherwise damage to the
device may occur.
• To prevent damage to the equipment, always connect the positive cable first.
Note The battery can only be installed in the upright position, or on its sides on a horizontal surface.
fig. 
on page 1
1.
Install the battery cables
2. To ensure a secure electrical contact, tighten the fasteners to the end of the threads, without using excessive
force.
Note If possible, secure the battery to the floor to avoid unexpected movements during the journey.
Note It is also allowed to connect automotive terminal clamps with M8 screws and appropriate washers.
NOTICE! Damage hazard
Never connect multiple batteries in series.
Control unit installation
NOTICE! Damage hazard
Never install the control unit in the engine compartment or in places where it is exposed to the elements.
Note Install the control unit as close to the starting battery as possible.
fig. 
on page 1
1.
Remove the two screws
2. Remove the lid
fig. 
on page 2
3. Secure the device on the mounting surface using appropriate fasteners.
14
to the corresponding terminals
.
.
using appropriate fasteners
 
.

Publicidad

loading