Sony AIVA CDC-R504MP Manual De Instrucciones página 6

To reinforce the bass sound
(H-BASS)
Press (H-BASS).
Each time you press (H-BASS), the H-BASS mode
is turned on and off.
Note
The H-BASS adjustment does not affect the signal
output from the AUDIO OUT REAR connectors on
the rear panel at the "SUB" (sub-woofer) position.
To set the equalizer (EQ)
You can select an equalizer curve for 7 music types
(HIP-HOP, VOCAL, CLUB, JAZZ, POPS, ROCK,
CUSTOM).
You can store a different equalizer setting for each
source.
To select the equalizer curve
1
Press (SOURCE) to select a source (TUNER,
CD or AUX).
2
Press (EQ) repeatedly to select the desired
equalizer curve.
To cancel the equalizing effect, select "OFF."
To adjust the equalizer curve
You can adjust and store the equalizer settings for
different tone ranges.
1
Follow the steps 1 and 2 above.
2
Press (PUSH-MENU).
3
Press (SEEK) (+) or (SEEK) (–) to select the
desired tone range; "LOW," "MID," or "HI."
4
Turn (PUSH-MENU) to adjust to the desired
volume level.
The volume level is adjustable from –10 to +10
dB by 1 dB steps.
5
Repeat steps 2 to 4 to adjust the equalizer
curve.
Note
When EQ is set to "OFF," you cannot adjust the
equalizer curve settings.
To restore the factory settings
You can restore the factory settings for the
equalizer curve settings while adjusting them.
During adjustment, press and hold
(PUSH-MENU) until the equalizer type (such as
HIP-HOP) appears on the display.
6
RADIO OPERATION
The unit can store up to 6 stations per band (FM1,
FM2, FM3, MW and LW).
Caution
When tuning in to stations while driving, use Best
Tuning Memory to prevent accidents.
Number buttons
(SEEK)(+)/(SEEK)(–)
Storing stations automatically
– Best Tuning Memory (BTM)
1
Press (SOURCE) repeatedly to select the
radio.
2
Press (MODE) repeatedly to select the band.
3
Press and hold (BTM SENS) until "BTM"
flashes on the display.
The unit stores stations in the order of their
frequencies on the number buttons.
A beep tone will be heard when the setting is
stored.
Notes
• If only a few stations can be received due to
weak signals, some number buttons will remain
their former settings.
• When a number is indicated on the display, the
unit starts storing stations from the one currently
displayed.
Receiving the stored stations
1
Press (SOURCE) repeatedly to select the
radio.
2
Press (MODE) repeatedly to select the band.
3
Press the number button ((1) to (6)) on
which the desired station is stored.
Button number
(SOURCE)
(MODE)
(BTM SENS)
Band
Frequency