Publicidad
Idiomas disponibles
Idiomas disponibles
30" ELECTRIC SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
2. Where local codes DO NOT permit, or if
connecting to a 4-wire electrical system, DO
NOT connect the cabinet-grounding conductor
to the neutral (white) junction box wire (see
Figure 6)
A. Disconnect the power supply.
B. Separate the bare copper and white appliance
cable wires.
C. Connect the white appliance cable wire to the
neutral (white) wire in the junction box.
D. Connect the 2 black wires together, then the
two red wires together.
E. Connect the bare copper grounding wire to the
grounding wire in the junction box.
Figure 6 – 4-WIRE ELECTRICAL SYSTEM
Cabinet Construction
To eliminate the risk of burns or fire by
reaching over heated surface units, cabinet storage
space located above the range should be avoided. If
cabinet storage space is to be provided, the risk can be
reduced by installing a range hood that projects
horizontally a minimum of 5" (12.7 cm) beyond the
bottom of the cabinet.
Countertop Preparation
The cooktop sides of the range fit over the cutout edge
of your countertop.
If you have a square finish (flat) countertop, no
countertop preparation is required.
Formed front-edged countertops must have molded
edge shaved flat 1/4" (0.64 cm) from each front corner
of opening.
Tile countertops may need trim cut back 1/4" (0.64
cm) from each front corner and/or rounded edge
flattened.
1/4"
(.64 cm)
If the countertop opening width is greater than the
minimum cutout width, adjust the 1/4" (0.64 cm)
dimension.
Countertop must be level. Place a level on the
countertop, first side to side, then front to back. If the
countertop is not level, the range will not be level. The
oven must be level for satisfactory baking results.
Cooktop sides of range fit over edges of countertop
opening.
5
1/4"
(.64 cm)
Min.
cutout
width
30.00"
(76.2 cm)
Formed or tiled countertop
trimmed 1/4" (.064cm)
back at front corners of
countertop opening.
Publicidad
