Publicidad
Idiomas disponibles
Idiomas disponibles
EN
8.5
ADJUST THE CHUTE DEFLECTOR
12
You can adjust the chute deflector up and down to change the
throwing distance of the snow.
Release the bail switch before you adjust the chute
deflector.
Do not push the deflector so far forward that a gap shows
between the deflector and the chute.
1. Push and hold the trigger on the chute deflector (12).
2. Move the chute deflector (12) up to increase the snow
distance.
3. Move the chute deflector (12) down to decrease the snow
distance.
8.6
LED HEADLIGHTS
13
Turning the headlights on
1. Push and hold the safety switch button (13).
2. Pull the bail switch (2) in the direction of the handle bar
to turn the headlights on.
Turning the headlights off
3. Release the bail switch (2).
WARNING
WARNING
2
3
English
8.7
OPERATION TIPS
•
If it is possible, clear the snow with the direction of the
wind.
•
In strong winds, lower the chute deflector to direct the
snow to the ground.
•
When you complete the work, let the machine operate for
a while to prevent ice formation in the discharge chute.
•
If the snow is deeper than 8", decrease the speed and let
the machine work at its own rhythm.
•
Do not use the scraper to remove compact snow and ice.
9
MAINTENANCE
Use only approved replacement parts.
Do not use strong solvents or detergents on the plastic
housing or components.
9.1
GENERAL MAINTENANCE
•
Before each use, examine the machine for damaged,
missing, or loose parts such as screws, nuts, bolts and
caps.
•
Tighten correctly all the fasteners and caps.
•
Clean the remaining snow on the machine with a brush.
9.2
REPLACE THE SCRAPER
24
24
Use only approved replacement scrapers.
10
CAUTION
CAUTION
25
WARNING
Publicidad
