Publicidad
Idiomas disponibles
Idiomas disponibles
EN
7.4
INSTALL THE CHUTE
DEFLECTOR
19
1. Align the tabs (18) on to the slots (16) on one side first.
2. Once you have engaged one tab on one slot push until
you hear a click. Repeat on other side.
3. Push the chute deflector (12).
4. Make sure that the tabs (18) engage the slots (16) on the
two sides.
5. Make sure that the posts (19) engage the holes (17) on the
two sides.
7.5
INSTALL THE CHUTE CONTROL
ROD
1. Align the holes (17) in the upper chute control rod (20)
and lower chute control rod (22).
2. Put the hitch pin (21) through the holes (17).
3. Align the arrows in the discharge chute and snow thrower
deck. Make sure the discharge chute faces forward.
12
16
17
18
21 20
22
17
English
4. Put the end of the chute control rod (1) straight through
the hole(6) in the bracket. Keep the grip handle down.
5. Push the chute control rod (1) into the hole (17) behind
the deck.
6. Turn the grip handle left and right to make sure that the
discharge chute moves in the same direction.
7.6
INSTALL THE BATTERY PACK
23
•
If the battery pack or charger is damaged, replace the
battery pack or the charger.
•
Stop the machine and wait until the engine stops before
you install or remove the battery pack.
•
Read, know, and do the instructions in the battery and
charger manual.
1. Open the battery door (11).
2. Align the lift ribs on the battery pack (23) with the
grooves in the battery compartment.
3. Push the battery pack (23) into the battery compartment
until the battery pack (23) locks into place.
4. When you hear a click, the battery pack is installed.
5. Close the battery door (11).
7.7
REMOVE THE BATTERY PACK
1. Open the battery door (1).
2. Push and hold the battery release button.
3. Remove the battery pack from the machine.
8
OPERATION
Wear eye protection during operation.
8.1
COLD WEATHER OPERATION
The safe battery operation temperature ranges from 1°F
(-17°C) to 113°F (45°C).
8
11
WARNING
WARNING
Publicidad
