Publicidad
Idiomas disponibles
Idiomas disponibles
English
Safety instructions
• Protect the product against moisture
• Protect the product against direct sunlight
• Avoid anti-static electricity when using the HDD
• Pay attention that the HDD can be hot when it is connected to the device.
Note:
In order to run all drives without any problem, please make sure, you place the
devices on an even ground. Please make sure that in spite of the vibration the
connection should be hold.
Hardware Installation
Connect a 2.5" IDE HDD / SSD: connect your IDE hard drive to the 44 pin
interface of the converter.
Connect a 3.5" IDE HDD: connect the 4 pin power cable to your IDE hard drive
and connect your hard drive to the 40 pin interface of the converter. Afterwards
connect the power cable to the converter.
Connect a 2.5" / 3.5" SATA HDD / SSD: connect your SATA hard drive to the 22
pin connector of the converter.
1.
Connect your drive to the converter.
2.
Connect the power supply to the DC jack of the converter and plug the power
supply into a power outlet.
3.
Switch on your computer.
4.
Connect the USB 5 Gbps cable to the converter.
5.
Now connect this USB 5 Gbps cable to a free USB port of your computer.
6.
Switch on the converter.
7.
There is no driver required, so the device is ready to be used.
8.
In order to use the Backup function, please perform the following installation:
Backup Software Installation
1.
Switch on your computer.
2.
Put the driver CD in the CD ROM drive.
3.
Open Windows Explorer, select: CD-drive\AI-OTB v1.3.0.5.exe.
4.
Follow the instructions of the software installation.
-9-
Publicidad
