Publicidad
Idiomas disponibles
Idiomas disponibles
Q
Q
1. Unpack the unit and confirm that you have all the hardware and required parts. Assemble the unit on a
carpeted floor or the empty carton to avoid any scratch.
2. Pick up the Ball Bearing Slides (Q) and separate the Slide Runners for the following steps. Extend the
Slide Runner all the way forward. Press the plastic release lever of the ball bearing slides up and pull
the Slide Runner complete out.
3. Attach the separated Slide Runners (Q) to the Drawer Side Panels (M and N) respectively with three 12
mm Screws (7) per slide runner. Make sure that the slide opening points towards the edge with
countersunk holes.
4. Securely screw four Small Cam Bolts (3) into the designated small holes on the Drawer Front (L) as
shown in the illustration.
5. Attach and align the Drawer Side Panels (M and N) to the Drawer Front (L) using four Small Cam
Locks (1) (Refer to page 3 on Cam Lock system operation supplement). As shown.
File Drawer Assembling
Q
3
3
L
6
Model # SPLS-BKLF
Q
Q
M
N
M
1
1
L
N
7
Q
M/N
Publicidad
