Publicidad
Idiomas disponibles
Idiomas disponibles
2.4.
Safe use of the device
a)
Do not overload the device. Use tools that are suitable for the application. A
correctly selected product will do a better and safer job for which it was
designed.
b)
Do not use the device if the ON/OFF switch does not function properly (does
not turn on and off). Units that cannot be controlled by the switch are unsafe,
cannot operate, and must be repaired.
c)
Disconnect the device from the power supply before adjusting, cleaning, or
servicing. This precaution reduces the risk of accidental start-up.
d)
Keep unused product out of the reach of children and anyone unfamiliar with
the device or this manual. Products are dangerous when used by
inexperienced users.
e)
Keep the product in good working order. Check before each use for general
damage or damage to moving parts (cracks in parts and components or any
other condition that may affect the safe operation of the device). If damaged,
have the device repaired before use.
f)
Keep the product out of the reach of children.
g)
Repairs and maintenance should be carried out by qualified personnel using
only original spare parts. This will ensure the safety of use.
h)
To ensure the designed operational integrity of the device, do not remove
factory-installed covers or loosen screws.
i)
Avoid situations in which the device stops under heavy loads during operation.
This can cause overheating of the drive elements and consequent damage to
the equipment.
j)
Do not touch any moving parts or accessories unless the device is unplugged.
k)
Do not leave the device switched on unattended.
l)
Clean the device regularly to prevent permanent dirt build-up.
m) The product is not a toy. Cleaning and maintenance must not be performed by
children without adult supervision.
n)
Do not tamper with the device to alter its performance or design.
o)
Keep the unit away from sources of fire and heat.
p)
Do not overload the device. Do not exceed the maximum load of the unit!
q)
Before using the machine, the operator must carry out a test run without load
and check the following:
•
•
•
•
r)
It is forbidden to tilt the suspended loads or drag them on the ground.
s)
Do not use the unit outdoors when it is raining or the weather conditions are
unfavourable.
does the switch allow the load to be lifted, lowered and stopped at
any time,
whether the crane moves freely and without disturbances,
whether there are any unusual noises during the operation of the
electric winch,
can the cable be rolled up and unrolled freely.
Publicidad
