t)
It is forbidden to walk or stay under the suspended load (and in its immediate
vicinity). It is forbidden to lift people or animals with this device.
u) Do not leave suspended loads unattended.
v) After mounting, balance the weight suspended from the hook block.
w) The load must not hang on the hook for too long, otherwise it may damage the
unit or lead to accidents.
x)
Check that the cable is not hanging too loosely. Always roll the cable properly
to avoid damaging it. If the cable is worn, it must be replaced.
b) If the device has been overloaded or subjected to strong shocks, it must be
checked by an authorized service technician before use.
c)
Avoid rocking the load.
d) The device enables the transport of objects on straight and curved rails.
e) Before suspending the load, always ensure that the space in which it will be
transported is clear of obstructions.
f)
Do not perform mechanical or similar work (welding, cutting, etc.) on
suspended loads.
g) Loads must be lifted off the ground at the slowest possible speed. When
transporting with the unit, avoid shocks, impacts and sudden changes in
speed. This will reduce the risk of the load falling from a height.
h) The device is not designed for continuous operation. Observe the operating
cycle of the device.
CAUTION! Although the product has been designed to be safe and has
adequate safeguards and despite the additional safety features
provided to the user, there is still a slight risk of accident or injury
when handling the product. Caution and common sense are advised
when using the product.
3. Instructions for use
The device is designed for vertical lifting and lowering of loads with the possibility
of moving in horizontal directions along the profile.
The device can be used in factories, farms, construction sites, for the assembly of
devices
The device is not intended for the transport of molten mass products!
The user is responsible for any damage resulting from misuse.
3.1. Product overview
and
for
loading
and
unloading
goods.