Descargar Imprimir esta página

MSW Motor Technics PROCAT 1200 Manual De Instrucciones página 36

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 133
f)
After installation, make sure that the feed wheels (11) fit properly to the rail,
roll freely and that the side plates (9) are spaced in a parallel manner.
NOTE: After installing the unit, verify its proper operation by suspending a light load
and rolling the unit several times along the rail before using it for the first time on
actual load.
BLOCK ASSEMBLY
The device is equipped with an additional accessory, which is a block. The use of the
block
allows
In order to assemble the block to the cable:
a) Unscrew and remove the block fasteners (B).
b) Guide the carrying cable with the hook (B) through the belt pulley.
c)
Attach all block parts (B).
d) Check the correctness of assembly, tighten any loose parts.
e) Attach the hook (5) of the carrying cable to the dedicated holder located at the
bottom of the winch (C).
CAUTION! All installation work should be carried out with the device disconnected from
the power supply!
you
to
lift
load
twice
as
big.

Publicidad

loading

Este manual también es adecuado para:

Procat 800Procat 500Procat 300