Global Industrial 292853 Manual Del Usuario página 2

Notes:
• The RESET button must be engaged for proper use.
• The power supply cord must be replaced if it fails to trip
when the TEST button is pressed and the unit fails to reset.
• Do not use the power supply cord as an ON/OFF switch.
The power supply cord is designed as a protection device.
• A damaged power supply cord must be replaced with a
new power supply cord.
• The power supply cord contains new user serviceable
parts. Opening the tamper-resistant case voids all
warranty and performance claims.
Note: Your unit's power cord and plug may differ from the
one shown.
A Reset Button
B Test Button
Part
Electronic Window
Air Conditioner
B A
Description
Window
Air Conditioner
Remote Control
Top Mounting Rail
(with sponge)
Lock Frame
Filler Panels
(with left & right label on
front face)
Sash Lock (2 holes)
Window Sash Seal
(sponge)
3/8" Screw
1/2" Screw
3/4" Screw
Foam Top Window Gasket
(thin sponge for backup use)
Insulation Strip (sponge)
AAA Battery
INSTALLATION & ASSEMBLY INSTRUCTIONS
Some assembly is required for your new air conditioner.
Please read and follow these instructions carefully.
1. This air conditioner is designed to be installed in a
standard double-hung window with a width between
23" and 36" (584mm-914mm) for model 292853.
26" and 36" (660mm-914mm) for model 292854.
2. The air conditioner can be installed without the
accordion panels to fit in a narrow window opening.
See the window dimensions.
3. The lower sash (the lower part of the window that
moves up and down) must allow for a 14.5" of vertical
clearance for model 292853 or 16" of vertical clearance
for model 292854 when open. (Fig. 1).
4. All supporting parts must be secured to firm wood,
masonry, or metal.
5. The electrical outlet must be within reach of the
power cord.
Qty.
1
TOP RAIL ASSEMBLY (Model 292853 Only)
1
Some assembly is required for your new air conditioner.
Please read and follow these instructions carefully.
1
The top rail must be assembled prior to installing the air
conditioner in the window.
Tools Needed: Phillips Screw Driver (not included).
2
Attaching the Top Rail to the Air Conditioner
1. Remove the air conditioner from the box and place on a
hard flat surface.
2
2. Remove top rail from the bottom of the packaging material
as shown in Fig. A.
3. Align the hole in the top rail with those in the top of the unit
1
as shown in Fig. B.
4. Secure the top rail to the unit with the 3/8" screws as
shown in Fig. C.
1
Top Rail
4
3
4
Fig. A
1
2
2
2
User's Manual
Bottom
Box
Fig. B
Fig. C
Fig. 1