Tripp-Lite SRCOOL3KTP Manual Del Propietário página 10

4. Installation
4.1 Installing the Unit on a Rack
Using a platform jack or forklift capable of reaching a parallel height with the rack, lift the unit next to the rack. Carefully slide
the unit onto the top of the rack. To access the mounting holes, remove the rear cover and front cover of the unit. Using the
supplied hardware, bolt the unit into place on the top of the rack.
4.2 LCD Screen Mounting (SR25UBAC or SR33UBAC Models Only)
An opening for the LCD display is provided in the door of the SR25UBAC and SR33UBAC rack enclosures.
To install the LCD:
• Place the LCD screen into the metal bezel to protect the glass edge of the LCD.
• Place the LCD screen into the opening in the rack door.
• Place the supplied fasteners into the slots only into the top two slots of the LCD panel.
• Hand tighten the screws until they make contact with the door.
• Torque the screws to 5 inch pounds (0.56 N-m). Do not exceed 6.17 inch pounds (0.7 N-m), or the glass may crack.
Figure 4-1: Install AC unit to rack (SR25UBAC rack shown.)
10
Note: The bottom two screws are
not used.