Publicidad
Idiomas disponibles
Idiomas disponibles
The following table shows possible problems and their causes:
Problem, cause, remedy
Problem
Cut is not
satisfactory, though
a
the motor runs
properly
b
Vibration
Pneumatic band
saw does not run
c
.
Pneumatic band
saw runs too slowly.
d
Other problems
We ask you to send the machine to the manufacturer, if necessary.
Unless otherwise specified, our "General Sales Terms" apply. Warranty and liability claims
in regards to persons or equipment damages are invalid, if one or more of the following causes
apply:
•
Improper use of the machine,
•
improper assembly, startup, operation or maintenance of the machine,
•
operation of the machine with defect safety devices or improperly fixed or non•functioning
safety and protection devices,
•
not considering of the instructions in the operating instruction booklet concerning transport,
storage, assembly, startup, operation, maintenance and setting up of the machine,
independent structural alterations or settings on the machine beyond the intended purpose,
•
inadequate supervision of wear parts,
•
improperly carried out repairs, inspections or maintenance,
•
catastrophic cases due to foreign objects, acts of god or other reasons which are beyond our
control.
54
TROUBLESHOOTING
Cause
Saw blade is not sharp.
Teeth point to the wrong direction.
Saw blade is not tightened.
Saw blade type (material, tpi) is
wrong for cutting the material.
Cutting speed of the saw blade is
wrong.
Material to be cut is not firmly
fixed.
Saw blade type (material, tpi) is
wrong for cutting the material or it
is dull.
Not connected to compressed air.
Insufficient air supply.
Iced sound absorber.
Clogged sound absorber.
Too little operating pressure
Hose diameter too small
Too little volume flow.
-
WARRANTY AND LIABILITY
Remedy
Install new saw blade.
Remove saw blade, change
teeth direction and install it
again.
Tighten saw blade.
Replace saw blade.
Increase or decrease
operating pressure.
Clamp the material near the
cutting location.
Replace saw blade.
Connect and open the
compressed air supply.
Check compressor and stop
valves.
Additionally check the
screen and the air inlet of the
machine.
Let defrost and use antifreeze
lubricant in future.
Clean and replace.
Increase operating pressure
Choose larger hose diameter
Increase volume flow.
Contact authorized expert
company
Publicidad
