DeLonghi Pinguino F250 Instrucciones De Uso página 29

I 8-08-2001 9:30 Pagina 29
RECOMMENDED OPERATING
CONDITIONS
Room temperature
Outside temperature
This appliance contains substances which, if liberated into the atmosphere, would damage the
ozone layer. Care should therefore be taken not to perforate the refrigerant circuit. At the end of
its working life, delivery the air conditioning unit to a special collection centre.
A) If your appliance comes fitted with a plug, it will incorporate a 13 Amp fuse. If it does not fit your socket, the plug should
be cut off from the mains lead, and on appropriate plug fitted, as below. warning: Very carefully dispose of the cut off
plug after removing the fuse: do not insert in a 13 Amp socket elsewhere in the house as this could cause a shock hazard.
With alternative plugs not incorporating a fuse, the circuit must be protected by a 15 Amp fuse. If the plug is a moulded-
on type, the fuse cover must be re-fitted when changing the fuse using a 13 Amp Asta approved fuse to BS 1362. In the
event of losing the fuse cover, the plug must NOT be used until a replacement fuse cover can be obtained from your nea-
rest electrical dealer. The colour of the correct replacement fuse cover is that as marked on the base of the plug.
B) If your appliance is not fitted with a plug, please follow the instructins provided below:
WARNING - THIS APPLIANCE MUST BE EARTHED
IMPORTANT
The wires in the mains lead are coloured in accordance with
the following code:
Green and yellow Earth
Blue
Brown
Technical specification
21 ÷ 32°C
21 ÷ 43°C
ELECTRICAL CONNECTION (U.K. ONLY)
Neutral E
Live
L
N
TECHNICAL SPECIFICATION
Power supply
Max. absorbed power
in air conditioning
Max. absorbed power
when heating (mod. F300)
Refrigerating capacity*
Number of fan speeds
Max. air flow
Dimensions of internal unit:
• width
• height
• depth
• weight
Dimensions of external unit:
• width
• height
• depth
• weight
* Standard conditions:
Room temperature
47% relative humidity
Outside temperature
41% relative humidity
As the colours of the wires in the mains lead may not corre-
spond with the coloured markings identifying the terminals
in your plug, proceed as follows:
The green and yellow wire must be connected to the termi-
nal in the plug marked with the letter E or the earth symbol
or coloured green or green and yellow.
The blue wire must be connected to the terminal marked with
the letter N or coloured black.
The brown wire must be connected to the terminal marked
with the letter L or coloured red.
see rating plate
"
"
"
2
460 m 3 /h
452 mm
800 mm
415 mm
35 kg
465 mm
480 mm
240 mm
12 kg
27°C
35°C
29