Electrical Connection; Technical Specification; Limit Conditions - DeLonghi AN Serie Manual Del Usuario

Sistema de aire acondicionado portátil
Ocultar thumbs Ver también para AN Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Start of season checks
Make sure the power cable and plug are undamaged and
the ground connection is efficient. Follow the installation
instructions precisely.
End of season operations
To drain all water from the circuit, remove the external cap by
unscrewing it in the anticlockwise direction then, remove the
internal cap from the drainage hose 10 on the back of the
appliance and allow the water to drain out into a basin (figure
M).
When the appliance is empty, replace the caps.
Clean the filter and dry thoroughly before putting back.
M
When the appliance is empty, replace the caps.
Clean the filter and dry thoroughly before putting back.

TECHNICAL SPECIFICATION

Power supply voltage
Max. absorbed power
during air conditioning
Refrigerant
Cooling capacity

LIMIT CONDITIONS

Room temperature for
air conditioning
see rating label
"
"
"
64 ÷ 104°F 18 ÷ 40°C
12
Transport, filling, cleaning, recovery and disposal of
refrigerant should be performed by a technical service
centre appointed by the manufacturer only.
The appliance should be disposed of by a specialist centre
appointed by the manufacturer only.
TO AVOID DAMAGE TO THE UNIT:
NEVER TRANSPORT OR TURN THE APPLIANCE UPSIDE DOWN OR
ON ITS SIDE. IF THIS OCCURS, WAIT 6 HOURS BEFORE TURNING
THE APPLIANCE ON, 24 HOURS IS RECOMMENDED. After the unit
has been on its side, oil needs to return to the compressor to en-
sure proper function. Without allowing the unit this time (6-24
hours) the unit may function for only a short time, and then the
compressor will break down from lack of oil.

ELECTRICAL CONNECTION

This appliance is equipped with a 3 prong grounded plug. The
plug must be connected into an outlet that is properly installed
and grounded in the accordance with all local codes and ordi-
nances. Do not modify the plug provided with the appliance.
If it will not fit the outlet, have a proper outlet installed by a
qualified electrician or relocate the unit to a proper outlet. If the
household electrical supply does not meet the above specifica-
tions, or if you are not sure your home has an effective electrical
ground, have a qualified electrician or your local electrical utility
company check it and correct any problems.
SAFETY PLUG
The appliance is fitted with a safety plug to protect the power
cable.
If power is cut off, unplug from the outlet and make sure the
power cable is undamaged.
If the cable is damaged, call the service center immediately.
If power cuts off frequently and the power cable is undamaged,
contact a qualified electrician.
OPERATION OF THE SAFETY PLUG
If the safety device incorporated in the plug trips and cuts off
the power supply, check that the power cable and plug are not
damaged.
If the power cable is undamaged, to restore operation press the
"RESET" button.
To verify correct operation of the plug, press the "TEST" button
periodically and make sure the appliance disconnects. If this is
not the case, contact the service center.
To restore operation, press the "RESET" button.

Publicidad

Tabla de contenido
loading

Tabla de contenido