Sony SDM-S205 Manual De Instrucciones página 34

Setup 4: Connect the audio cords
If you are not intended to output audio, you do not need
this connection.
1
Connect the display's audio input jack and audio
output jack of the computer or other audio
equipment using the supplied audio cord.
to audio output of
the computer or
other audio
equipment
audio cord (supplied)
2
Connect the audio cable (not supplied) securely to
the display's audio output jack.
Audio output will be changed when the display's audio input and
audio output connection has been completed.
Connect audio equipment that is within the input range shown in
the display's audio input specifications. Too high of an input may
cause damage to the display.
Downloaded from: https://www.usersmanualguide.com/
to the audio
input
to the audio output
audio cable
(not supplied)
Setup 5: Connect the power cord
1
Connect the supplied power cord securely to the
display's AC IN connector.
2
Connect the other end securely to a power outlet.
2
to a power outlet
power cord (supplied)
Setup 6: Secure the cords and
close the connector cover
1
Draw the cords and cables through the cable holder
as illustrated.
2
Close the connector cover.
Note
When bounding the cords and cables, be sure to loosen them a little. If
they get pulled hard they may come off from the connectors/plugs as you
adjust the display angle. If you stretch the cords and cables too hard they
may get damaged.
9
1
to AC IN
GB