Descargar Imprimir esta página

Sony SDM-S205 Manual De Instrucciones página 35

Ocultar thumbs Ver también para SDM-S205:

Publicidad

Setup 7: Turn on the display and
1
Make sure that the 1 (power) Indicator blinks red. At
the time of your purchase, the MAIN POWER switch
is set to the \ side.
Note
When the MAIN POWER switch on the right side of your display is not
set to the \ side, press the \ side and check that the 1 (power) indicator
blinks red.
2
Press the 1 (power) switch located on the front
right of the display.
The 1 (power) indicator lights up in green.
3
Turn on the computer.
Downloaded from:
https://www.usersmanualguide.com/
computer
MAIN POWER
lights in green
If no picture appears on your screen
• Check that the power cord and the video signal cables are
properly connected.
• If "NO INPUT SIGNAL" appears on the screen:
– The computer is in the power saving mode. Try pressing any
key on the keyboard or moving the mouse.
– Check that the input signal setting is correct by pressing the
OK button (page 12).
• If "CABLE DISCONNECTED" appears on the screen:
– Check that the video signal cables are properly connected.
– Check that the input signal setting is correct by pressing the
lights in red
OK button (page 12).
• If "OUT OF RANGE" appears on the screen:
Reconnect the old display. Then adjust the computer's graphics
board within the following ranges.
Horizontal
frequency
Vertical
frequency
Resolution
For more information about the on-screen messages, see "Trouble
symptoms and remedies" on page 20.
No need for specific drivers
The display complies with the "DDC" Plug & Play standard and
automatically detects all the display's information. No specific driver
needs to be installed to the computer.
The first time you turn on your computer after connecting the display, the
setup Wizard may appear on the screen. If this is the case, follow the on-
screen instructions. The Plug & Play display is automatically selected so
that you can use this display.
The vertical frequency turns to 60 Hz.
Since flickers are unobtrusive on the display, you can use it as is. You do
not need to set the vertical frequency to any particular high value.
10
Analog RGB
Digital RGB
28–92 kHz
28–75 kHz
48–85 Hz
60 Hz
1600 × 1200 or less

Publicidad

loading