Descargar Imprimir esta página

GreenWorks MO40L01 Manual Del Operador página 12

Publicidad

Idiomas disponibles

Idiomas disponibles

EN
8.3
STORE THE MACHINE
Remove the safety key.
Remove the battery pack(s).
Clean the machine before storage.
Make sure the motor is not hot when you store the
machine.
Make sure that the machine does not have loose or
damaged parts. If it is necessary, follow these
instructions:
Replace the damaged parts.
Tighten the bolts.
Speak to a person at an approved service center.
Store the machine in a dry area.
Make sure that children cannot come near the machine.
8.4
STAND THE MACHINE ON END
18
1. Remove the grass catcher.
2. Pull and turn the handle knobs 90°.
3. Fold down the handle.
4. Turn the handle knobs 90° to lock the handle into
position.
5. Stand the machine on end and make sure that the brackets
touch the floor.
Storage Switch
The machine has a storage switch that prevents its startup in
the storage position.
It is necessary to remove the safety key and the battery pack
to prevent accidental startup or unapproved use. The storage
switch does not replace this function.
English
9
TROUBLESHOOTING
Problem
The handle is not
in position.
The machine does
not start.
The machine cuts
grass unevenly.
The machine does
not mulch correct-
ly.
The machine is
hard to push.
There is a high vi-
bration in the ma-
chine.
12
Possible cause
Solution
The bolts are not
Adjust the height
engaged correctly.
of the handle and
make sure that the
knobs and bolts
are aligned cor-
rectly.
The battery ca-
Charge the battery
pacity is low.
pack.
The handle switch
Replace the handle
is defective.
switch.
The safety key is
Put in the safety
not put in.
key.
The lawn is rough. Examine the mow-
ing area.
The blade height is
Adjust the blade/
not set correctly.
cutting height to a
higher position.
Wet grass clip-
Wait until the
pings attach to the
grass dries before
deck.
mowing.
The mulch plug is
Install the mulch
missing.
plug.
The grass is too
Increase the blade/
tall, or the blade
cutting height.
height is too low.
The grass catcher
Empty the grass
and the blade
clippings from the
drags in thick
grass catcher.
grass.
The blade is un-
Replace the blade.
balanced and
worn.
The motor shaft is
1. Stop the mo-
bent.
tor.
2. Remove the
safety key and
battery pack.
3. Inspect for
damage.
4. Repair the ma-
chine before
you start it
again.

Publicidad

loading

Este manual también es adecuado para:

Lmf413